Hi group,

I send you a drawing of my dry

pan/support.

The one you see is for a single rotor,I

can do the

same for 2 or 3 rotor.

It is made out of aluminium 6061 t6  3/4

inch,CNC

machine.

You can see the bores to insert Lord

rubber.

The oil pump inlet is not shown but it is

there!

For those who are interest,here is my

email.

cgtyy@yahoo.ca

Thank you

Frank

How much Frank? Neat idea.

Paul Lamar

Francois St-Germain wrote:

Thanks Paul,
The one rotor support cost around 550$ US
For the 2 or 3 rotor it will be something like

800 or

900 I do not know yet, But I will not make a

living

out of this!

I have forgot to mention that it can be insert

between

the original Pan and the engine to act as a

simple

engine mount.

Thanks
Frank

Very elegant solution to motor mount brackets

Frank.

That is the trouble with those NC mills. They

are expensive and

they MUST be paid for.

Paul Lamar

Frank
Where do you buy your aluminum stock?
Royce

Francois St-Germain wrote:

I buy my aluminium up here in Quebec, Alcan produce
it.
It is not the expensive parts.It is the CNC that cost
a lot.
Laser or water cut are not accurate enough in
aluminium that thick.
Are you looking for Alu?

Frank

Yes we are looking for a good source for heavy plate.
Royce

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org