Jim Brewer wrote:

Don't know if this stuff would be of any use on the rotary but I can

think of several uses. Anyway here it is FYI.

Jim Brewer

http://www.fuji-prescale.com

Bill Ebner
Sensor Products Inc.
188 Rt. 10 Suite 307
East Hanover, NJ 07936-2108 USA
www.fuji-prescale.com
973.560.9092
fax 973-884-1699
pressuresolution@earthlink.net

I've used this stuff before when troubleshooting bad gasket joints.  It's
great for finding out whether an assembly is too warped to get good
compression on the gasket, whether it is making contact at all, whether the
bolt torque is giving the preload you want, etc.

I suppose it would be very useful in fitting up a one-of-a-kind custom piece
to see if you need to spend more $$ to have it ground or lapped flatter.

Tom Kendall

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org