Thomas Parkes wrote:
I have long suspected that the higher Mazda oil pressure may be part of
the
problem. That's why I installed the .165 restrictor supplied by Main
Turbo
in the first place. Gary Main told me that was the smallest restrictor
approved for a TE-06. Now, here's a problem for one of the engineers on
the ACRE list: If a .165 restrictor is okay for the typical 60-70 psi
aircraft oil system, how much smaller an orifice would supply similar
volume
and pressure for a 20b's 90 psi? Any help would be
appreciated--including
how to go about reducing the diameter of the restrictor orifice (braze
and
re-drill?).
Another alternative may be fabrication of an oil bypass system similar to
Corky Bell's diagram on p. 42. Somehow, I have a feeling that would be
another steep learning curve for this non-engineer.
Thanks,
Tom Parkes
I don't know how to calculate that Tom. Perhaps someone else
on here knows how.
You may have to do this by trial and error. You might have to set up
a graduated beaker and run the engine for a few seconds and pump
oil through the orifice and calculate the flow rate from that data.
Also set up the pressure gages like Corky shows to be sure you are
getting the required pressure in the turbo. This should pay off in
the long run if it keeps the turbo alive. All of us doing turbo's
would be greatly in your debt.
BTW a lowly 13B stock turbo uses a 3/4 inch drain back shielded from the
radiant heat of the turbine housing.
Paul Lamar
Paul:
Thanks for your encouragment. Last night I awoke with the realization that
I gave you the wrong dimensions for my existing restrictor orifice. First
thing this morning I went to the hanger and checked it. In the reality of a
cool, winding Prescott morning, the actual restrictor will just accept a #42
drill bit, so its about .093 diameter.
Let's see: .093 id @ 90 psi.............versus .065 @ 30 psi. Surely
someone out there can compute this. Is the pressure and volume a direct
ratio?
The problem is the exact shape of the tiny hole can change the flow greatly.
I think you are going to need to bite the bullet and measure the flow. PL
Question #2: How do I measure oil pressure inside a turbo housing? My
in-line restrictor is inside the L-bracket where oil enters the turbo.
Good question. Probably not practical. Better to move the restrictor
up stream. No difference in the flow but it is a lot easier to measure
the pressure applied to the turbo bearings just before the oil goes into
the turbo bearing housing after the restrictor. BTW I wonder if the ceramic ball
bearing turbo's are this critical about oil flow and pressure? PL
Seems to me that once the oil enters the turbo housing the pressure will
drop off to some value near atmospheric, especially if it then drains by
gravity to the oil pan. In my present case, it is being sucked by a
scavange pump at around 100 gph.
Any input anyone?
Tom Parkes
tparkes@earthlink.net
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org