Subject: 13B side housings
From: ACRE NL
Date: 5/2/2002, 2:32 PM

Tom Brown wrote:

I understand the side housings are nitridedand grinding/lapping them flat
will remove this thin treatment.

Tom Brown

If over done. Depends on how much is taken off. I forgot the number.
They can also be re nitrided. One of the big problems is the O-ring
groove depth get too shallow if too much is taken off.
So far side housing wear has not been a major problem.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org