Subject: Ernesto's turbo Cozy motor mount.
From: ACRE NL
Date: 5/2/2002, 2:42 PM


This uses the motor plate idea or the new cast bell
housing
idea.
It is like the Kis Cruiser but the tripods are reversed
and
attached
up
near the top of the spar and down near the landing gear
pivots.
Gives plenty of room along side the engine for the HKS
manifold
and TO4 turbo.

I still need a bunch of dimensions Ernesto.

Paul Lamar

Thank you for wanting to help me.
My firewall is a flatten oval, 38" wide by 31" tall.
W.L. 34, top of firewall
W.L. 23.5, B.L. 16.5, stock engine mount to firewall holes,
left
and
right
W.L. 22, top of spar
W.L. 21, Crank shaft, C/L of motor
W.L. 20.25, B.L. 36.5 inside wing mount bolt holes, 0.5",
right
and
left
W.L. 17.4, trailing edge of wing.
W.L. 14.6, B.L. 7.0, stock bottom engine mount holes, right
and
left
W.L. 3.0, Bottom of firewall
Firewall to prop face needs to be 41"
Thrust line is 1.5 degrees up from C/L of motor
Spar is flat behind (.25") the fire wall until about B.L. 34
then
sweeps
back about 10 degrees just before the wing mount holes.
Thanks again Paul!
Ernesto

Paul Lamar:
W.L = water line
B.L = ????

Butt line, lines that run laterally across the aircraft starting
from
the
centerline of the aircraft running out board to the tips of each
wing,
left
or right.  Just another station line.
Attached is a photo of my full size firewall plans.
Thanks,
Ernesto


OK. One more question. What are the coordinates on the firewall
directly behind the large bolt that the landing gear pivots
on? That would be a very good point to feed in the compressive
loads
from the lower motor mount tubes.

Paul Lamar

The best I could figure is WL 6 (- + 1"), BL 13.
Ernesto

Here's another photo.  This is Paul Lee's plane.
Ernesto

Here is the latest. Check the dimensions.

Now we need some details of the firewall in the upper mount area
and details of the spar web so we can draw some mm attach fittings.

Paul Lamar

Attached are more details.  Can the side braces be removable for maintenance
as shown on the modified gif?
Ernesto

Absolutely.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org

1czymmbv.gif

mmdetail.jpg

spar.jpg