Subject: Turbo oil drain back specs
From: ACRE NL
Date: 5/2/2002, 2:00 PM


The rest is a piece of cake, you'll see.

Unfortunately I don't know anything about Turbos so I
couldn't even guess what the practical difficulty
factor
would be. But, I do know this: "There's always a way"

                                Keep me posted,
                                    Butch

*********************************************************

Hi Paul;

I'm somewhat confused as to exactly what Tom's problem
is, and what he really needs to know, mostly due to my
ignorance of Turbo systems I guess. Since you are savvy
with Turbos here is a nifty formula developed in the lab
I use, to figure pressure drop across an orifice of a
given size or flow. This formula is for Hydraulics
application but I'm sure the viscosity of Turbine lub is
approximately equal. In either case it should get him
pretty close.

Delta P = [GPM / (23.5 x A)]squared
                A = Area of orifice

For Tom's application since he knows Delta P:

GPM = (23.5 x A) x the square root of Delta P

This should enlighten Tom and put him in great shape.

                                     Thanks,
                                         Butch

We think Tom's main problem is too much oil is getting to the turbo
and is getting by the labyrinth seals and into the turbine housing and is coming
out as smoke. The Mazda uses higher oil pressure than piston
engines so the orifice sizes are probably too big. Another of Tom's
problems is the orifice is right at the turbo housing so he cannot easily
get a pressure gage in there to check the pressure the turbo is actually
seeing. 

Perhaps related to this is the drain back tube size. Tom is currently using
a 5/8 ID tube while Mazda uses a 3/4 ID drain back tube. Another problem
is the drain back tube is adjacent to the red hot turbine housing so 
that turns any oil that is still fluid (after going through the turbo
bearings) into yet more foam. Mazda shielded this line in 1989. See the pic.
Perhaps Tom's electric scavenge pump is cavitating trying to suck foam.

Imagine the problem Mazda would have with emissions if any oil at all 
gets by the turbo labyrinth seals.

Paul Lamar

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org

drain-back-heat-shield4.jpg