Vance W Jaqua wrote:

Paul - thought you might enjoy this out of the current big V8 magazine
seems they bad mouthed the import guys a while back _ Vance

There must be a dozen like that one. Here is a picture of Abel Ibarra's
dating back to 1997. Late runs with this car are over 180 and well under 8

seconds.

Paul Lamar

Is anyone running a "slingshot" type rail with an engine of this caliber?
I have not seen anything.
Should be somewhere around 1100lbs, (or less), and really run!

Archie

Not to my knowledge Archie. I think the 3 rotor RX7's are slower because
the CG is lower and they don't hook up as well as these old sedans.

I would design the rail so the rotary motor was in back of the axle :-)

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org