Subject: 13B side housings
From: ACRE NL
Date: 5/4/2002, 1:26 AM


<< > Paul, With reguards to nitriding, it is very thin at about .0005 in on
 > average. If you cut the side plate at all you remove the nitriding. Lots of
 > the car guys run without it then they grind the side plates. They do
replace
 > or regrind them often though. Bill J.


 The need to do this is rather rare in an aircraft use for some strange reason
 but the side plates can always be re nitrided and re lapped.

 Tracy went 650 hours on a junkyard engine and the side plates
 were still in good shape. Maybe it was the Marvel Mystery Oil :-)

 Paul Lamar >>

 Paul,
 I wonder if the race car guys score their sideplates more often due to
gyroscopic action of the rotors at high rpm's and sideloads with frequent
violent changes in direction? Just speculating. Bill J

The race car guys run them up to 10,000 RPM too.
So far nobody in aircraft use uses more than about 7500 RPM for take off.
Most use only about 6000 RPM. A walk in the park for a rotary.

Paul Lamar

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org