Frank

 > We are looking at alternatives.  Comparing the cost of making the
 > castings  and then finish machining, or milling from plate.
 > We can xast from A365, we have plenty of ingots.  Adding the time, flux,
 > DeGausing etc. can also add up, not to mention the time and effort.
 > The plate that we would need would be:
 > 2024-T3  3-14"x14"x 61MM. And 1-14"x14"x60mm.
 > Royce

Check
www.shapirosupply.com

they sell aluminum and steel, website says up to 10" thick available.

Bill Schertz
KIS Cruiser #4045

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org