Subject: New cast bell housing
From: ACRE NL
Date: 5/4/2002, 10:05 AM


The design of the cast bell housing motor mount  is coming along
Here is a back view.

Paul Lamar

Here is the front view. The mounting boss for the starter is yet
to be added. The pattern will be carved out of high density foam
on a 3D NC mill.

Paul Lamar


-Gordon Robertson wrote:

Hi Paul,

I am still not sure where the third pickup point for mounting the engine is.
Or do you use the two front mounts for the entire job?  In which case, what
holds the motor firm in the pitch axis?

Gordon Robertson
RV-8 finishing

Many ways of doing it. The loads are super low when you get the main
mounts near the engine/PSRU/Prop/Starter CG. The advantage of the
strut with the two rod ends is you can adjust the thrust line for
minimum drag and top speed. Commonly done with Questair Ventures.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org

rear-mount-bracket2.gif

rear-mount4.gif

TRIPOD.GIF

quest-rear-mount.jpg

rear-t-mount2.jpg