Subject: 250 hour oil scraper O-ring report
From: ACRE NL
Date: 5/5/2002, 9:14 AM


BTW, anybody know if the "Gunk" carb cleaner is "babit safe"?

Finn


Tom Kendall replies:

I sure hope so!  I just soaked all three of my rotors in the stuff for 24
hours each.  Actually, Bruce Turrentine's video shows using the Gunk brand
carb & parts cleaner for the rotors, so I suspect he's had real world
experience with it.

The cleaner is a hydrocarbon based emulsifier, not a caustic soda.  Babbit
is tin and lead.  The gunk cleaner should be just fine.  My babbit looks
brand new after the soak.

Finn Lassen wrote:

Thanks Tom.
I'll probably replace all four bearings (again!) anyway. A couple of the
bearings are worn down to the copper in some spots and all four are scratched.
You just can't run that engine without oil pressure, not even for a couple of
minutes at low RPMs in an attempt to build up pressure. Of course using the same
old oil filter after correcting in/output to the filter probably didn't help
either :)

Finn

I think you should try some 500 degree F Greavey oil O-rings Finn. In case 
you overheat your oil again. They are cheaper than new oil O-rings from Mazda.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org