BTW, anybody know if the "Gunk" carb cleaner is "babit safe"?
Finn
Tom Kendall replies:
I sure hope so! I just soaked all three of my rotors in the stuff for 24
hours each. Actually, Bruce Turrentine's video shows using the Gunk brand
carb & parts cleaner for the rotors, so I suspect he's had real world
experience with it.
The cleaner is a hydrocarbon based emulsifier, not a caustic soda. Babbit
is tin and lead. The gunk cleaner should be just fine. My babbit looks
brand new after the soak.
Finn Lassen wrote:
Thanks Tom.
I'll probably replace all four bearings (again!) anyway. A couple of the
bearings are worn down to the copper in some spots and all four are scratched.
You just can't run that engine without oil pressure, not even for a couple of
minutes at low RPMs in an attempt to build up pressure. Of course using the same
old oil filter after correcting in/output to the filter probably didn't help
either :)
Finn
I think you should try some 500 degree F Greavey oil O-rings Finn. In case
you overheat your oil again. They are cheaper than new oil O-rings from Mazda.
Paul Lamar
When did I overheat my oil? No evidence of that. As I wrote the oil O-rings are still
soft with no "set" to them. I'm not planning on replacing them.
Of course the carbon build-up could be taken as an indication of failing O-rings,
although I think it's from running way too rich.
Finn
Subject: 250 hour oil scraper O-ring report
Date: Sat, 04 May 2002 00:22:39 -0400
From: Finn Lassen sniped.....
"I'm not aware of overheating the oil: below 212F in and 250 oil pan
temps. Possibly a very brief (few minutes) temp rise to maybe 300F oil
pan temp."
300 F in the pan sounds like a bunch. Most rotary mechanics will say
that is way too much. The rotor could have been much hotter.
The apex seal part of the rotor typically runs 500 degrees.
Perhaps that is why your bearings are bad. Maybe not.
Are you running Mobil 1? Two cycle oil in the fuel?
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org