Subject: Evaporator cores a book
From: ACRE NL
Date: 5/5/2002, 9:34 PM


 The bottom line is, as we have seen  over and over again, get the air
flowing
 > > through the rad(s) freely first with a proper diffuser intake duct and
an open
 > > and free exit area. Use as large an area rad as possible and not too
thick. Do
 > > this before you add more or larger radiators.
 > >
 > > Paul Lamar


    If the question is still "how do I tell if it is a good one?" then just
poke a shrader valve on any GM car and see if the system is still holding
pressure. These thing work great as radiators and oil coolers. Been there,
did it. Not for some great engineering cause to prove anything. Just had no
money. I got them from behind repair shops.
Even if they leak freon, they will often not leak water. They will leak hot
oil, however.
    An interesting note from the race track. Things were going well for us
for a change and I was asked to help get a fan going on a showroom stock
Honda. The driver, Roger Schroer, a test driver for Honda said he was
overheating the water (coolant).
The temp was 44 degrees in rain and high winds. How could this be I asked. I
thought the fan would not come on anytime the ambient was this low. Not true
said the Honda engineer. Without the fan running behind the postage stamp
sized radiator, it will over heat. This radiator is just over an inch thick.
Ideal you would think. Anyway just think of a 3 1/2" thick Harrison core with
a little fan behind it. Ideal I would think, and cheap too.

Lynn E. Hanover


The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org