Subject: Front oil seal worked loose.
From: ACRE NL
Date: 5/5/2002, 8:18 PM


I do not know what's wrong with my Outlook, I cannot enter a
subject, maybe you can add one for me.

I am not surprised :-)

I found my oil leak. It was on the front cover. The eccentric shaft
front cover oil seal worked loose out of the cover and was riding up
against the e-shaft pulley. I should have noticed the small amount
of rubber dust before but I assumed it was from the alternator belt.
Has anyone ever heard of this happening before? The seal is so
simple to install I don?t know how I could have screwed that up.
Maybe caused by harmonics from the pulley driving the alternator?

Chuck Dunlap

Its a new one on me
Chuck. Real strange. I know of no way of locking
it in. Perhaps a real thin sheet metal washer with small machine
screws safety wired somehow.

Paul Lamar


Here's another assembly tip from the 2-stroke guys.  Put a film of 'blue' locktite on
the outside of the seal before inserting it into the bore.  I have seen others use RTV
for the same purpose.  We always did this to prevent air leaks into the crankcase.

Ken Powell

I took a look at a front cover and you could also probably stake it with
a center punch in about three places front and back.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org