Subject: Tuned mufflers optimum pipe lenght
From: ACRE NL
Date: 5/5/2002, 4:42 PM


As I am slowly learning some of the powerful free software tools
at my disposal I have come up with this single graphic
that illustrates the importance of the exhaust pipe length
and a way of implementing it with a simple compact muffler
design that will fit under the cowl of most side by side
airplanes.

The chart is from Mazda SAE paper 841017.
BMEP is more or less the same as torque which at a given RPM
translates to HP. The higher the BMEP at any RPM the greater
the HP.

From this chart you can see that 31 inches is about right
and that is the length of the square pipe wrapped around the
muffler can. If somebody wants to build one of these I will
test it on our new dyno in about couple of months or so.

Paul Lamar

Yes I think it does to a certain extent but I am not entirely
sure to what extent. That data was taken with a p-port and a 
relatively short intake pipe but I know not what diameter. 
Diameter of the pipe also has an effect on tuning surprisingly.
Mazda did that because they were looking for good power
over a wide RPM range. Very important for a road racing car.

Here is a chart of P-port intake length verses BMEP from the same 
SAE paper. I suspect we are running pipes a bit too long
for 6000 to 7000 RPM. I think Chuck Dunlap may be having this problem.

I removed my oil filler neck and will
be looking into a way of shortening the intake pipes just
a bit and still get oil in the engine. I will move the intake 
plenum up over the rotor housing a bit.

The time has come for a little dyno tuning to nail some of this stuff
down for aircraft use.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org