Al Gietzen wrote:
Some time back I reported on my custom oil cooler, and the flow tests I did
to determine pressure drops through the core. More recently I realized that
all the data was off by a factor of 2 - too low. One of those dumb mistakes
you realize later. I read the water manometer data from a fixed zero line
on one leg of the manometer, recognizing that the actual head was double
this amount as the difference between the surfaces in the two legs. But
after recording the data I forgot about the factor of 2; and went happily
about doing the regression analysis and extrapolation; and reporting
results, oblivious of my error.
Fortunately, it makes little difference to me since the pressure drops are
still low enough and should work just fine.
For anyone using the data, here is the corrected data:
Core thickness - 3.35", 14 fins/in
Core Air velocity Press. drop
9.97 fps (6.8 mph) 0.26"
19.95 (13.6) 0.75
25.37 (17.3) 1.12
31.0 (21.1) 1.56
34.0 (23.2) 1.83
40.0 (27.3) 2.44
The 40 fps is my design point; core area just over 4 times the inlet area,
climb speed about 120 mph. The presure drop values for air velocities above
25 fps are obtained from a regression analysis quadratic fit (you know,
getting an equation that fits the measured values, 8 of them, very well, and
then using it to calculate for air speeds where you couldn't measure) So
there is some unknow error margin (hopefully small) on the higher values.
Similarly, my 2.5" thick radiator, 16 fins/in, will have a design point p.d.
about 1.8" h20.
Al Gietzen
Al, pressure check that oil cooler for at least 100 psi. So far we have had
two in-flight fires and one fatal crash because of burst non Mazda oil coolers.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org