Subject: Front oil seal worked loose.
From: ACRE NL
Date: 5/6/2002, 4:55 AM


I do not know what's wrong with my Outlook, I cannot enter a
subject, maybe you can add one for me.

I am not surprised :-)

I found my oil leak. It was on the front cover. The eccentric shaft
front cover oil seal worked loose out of the cover and was riding up
against the e-shaft pulley. I should have noticed the small amount
of rubber dust before but I assumed it was from the alternator belt.
Has anyone ever heard of this happening before? The seal is so
simple to install I don?t know how I could have screwed that up.
Maybe caused by harmonics from the pulley driving the alternator?

Chuck Dunlap

Its a new one on me
Chuck. Real strange. I know of no way of locking
it in. Perhaps a real thin sheet metal washer with small machine
screws safety wired somehow.

Paul Lamar


Here's another assembly tip from the 2-stroke guys.  Put a film of 'blue' locktite on
the outside of the seal before inserting it into the bore.  I have seen others use RTV
for the same purpose.  We always did this to prevent air leaks into the crankcase.

Ken Powell

I took a look at a front cover and you could also probably stake it with
a center punch in about three places front and back.

Paul Lamar


Staking was my first thought, but  after I looked at the generous chamfer that Mazda puts on
that bore, I wouldn't.  The shop manual just says to drive it in. Hylomar, Locktite 242,
RTV, there's a world of solutions that will keep that seal in place, but I don't think I'd
try to stake it.  My 2 cents.

Rick Girard
13B + LEZ

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org