Subject: Front oil seal worked loose.
From: ACRE NL
Date: 5/6/2002, 8:57 AM


I do not know what's wrong with my Outlook, I cannot enter a
subject,
maybe you can add one for me.

I am not surprised :-)

I found my oil leak. It was on the front cover. The eccentric
shaft
front cover oil seal worked loose out of the cover and was
riding up
against the e-shaft pulley. I should have noticed the small
amount
of
rubber dust before but I assumed it was from the alternator
belt.
Has
anyone ever heard of this happening before? The seal is so
simple to
install I don?t know how I could have screwed that up. Maybe
caused
by
harmonics from the pulley driving the alternator?

Chuck Dunlap


Its a new one on me
Chuck. Real strange. I know of no way of locking
it in. Perhaps a real thin sheet metal washer with small machine
screws
safety wired somehow.

Paul Lamar


I don't know if this applies to the rotary, but with piston
engines, front & rear seal problems are usually related to
the main bearings being too loose.

Charlie England

Gee, I don't have that problem with outlook. I have others!
Check those spacers (there are many different letter and numbered
spacers for eccentric installation) and the installation of same, ie and
the torque on the pulley bolt. Spacers take up the slop and you should
dial in specified amount.
[Marc Wiese]


The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org