Subject: Tuned mufflers optimum pipe length
From: ACRE NL
Date: 5/6/2002, 6:04 AM


As I am slowly learning some of the powerful free software tools
at my disposal I have come up with this single graphic
that illustrates the importance of the exhaust pipe length
and a way of implementing it with a simple compact muffler
design that will fit under the cowl of most side by side
airplanes.

The chart is from Mazda SAE paper 841017.
BMEP is more or less the same as torque which at a given RPM
translates to HP. The higher the BMEP at any RPM the greater
the HP.

From this chart you can see that 31 inches is about right
and that is the length of the square pipe wrapped around the
muffler can. If somebody wants to build one of these I will
test it on our new dyno in about couple of months or so.

Paul Lamar

Joseph Berki wrote:

How would one build this muffler?  Would it use pre-bent stainless pipe
welded together around the can?  

No. All flat sheet.

Would the can be made from sheet plate
stainless?  

Yes.

How difficult is stainless to cut? 

Easy if you have a plasma cutter. Tracy Crook has one and might cut it for
you if you send him the SS sheet and patterns. Most custom commercial restaurant
kitchen builders deal with stainless all the time and probably have
a plasma cutter. Some have a computer controlled plasma cutter and you
merely enter the drawing.

If you made the square
stainless out of sheet that would require much welding. 

Yes but stainless is very easy to tig weld if you back up the weld
area with inert gas. Any good welder will know how to do that.

Thanks for
converting kg/cm2 to psi

Joe Berki


 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org