You don't need to make an elipse- you are spiraling the sides of the
headers around the 'can', so the inside edge of the spirals is
slightly larger than the outside diameter of the can. To figure out
the exact diameter, think of the circumference of the 'can' as one
side of a triangle, and the offset, that is, the distance of the
'pitch' of one revolution of the spiral, as the other side of a right
triangle. The hypotenuse of the triangle is the equall to the
circumference of the inner edge of the spiral wrap. Hope I have
obfuscated this for everyone.:-)
If I only had the time, I'd build one of these myself.
Brian Trubee
I obviously don't get it. If you are starting with 2" wide flat
strips and wrapping them around the six inch diameter core, good
luck. Jerry
The outer part of the tuned square channels are trapezoids.
The sides are round flat strips with an OD of about ten inches
and an ID of about six inches. Looks like a big washer with a cut
in it. The inner walls of the channels is the can skin for the
most part. When done the channels would look like pig's tails.
Best to make one out of thin cardboard or poster board to
get a feel for what is required. Hot glue works real good to make
these kinds of mockups.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org