Subject: Tuned mufflers optimum pipe length
From: ACRE NL
Date: 5/6/2002, 1:55 PM

Tracy Crook wrote:

The Limo EZ is 22" at the firewall.  Some additional area can be used
beween  wing root  and the upper and lower cowls.  I am all for smaller
diameter.  I want to feed the output of the muffler into an augmenter
located below the engine.  Can the welds be done with a Henrob or should
it be left to professionals?  Thanks

Joe Berki


The Henrob works very well on stainless tubing which tends to hold itself in
alignment.  I've done all my own exhaust systems using 321 stainless and the
Henrob.

 Unfortunately, whenever I've tried to weld any thin (.035 - .062)  flat
stainless  it immediately turned into something resembling a potato chip due
to the high coefficient of expansion on SS.  Probably must use TIG on
anything made of flat SS.

Tracy Crook
tcrook@rotaryaviation.com
www.rotaryaviation.com

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org