You don't need to make an elipse- you are spiraling the sides of the headers around the 'can', so the inside edge of the spirals is slightly larger than the outside diameter of the can. To figure out the exact diameter, think of the circumference of the 'can' as one side of a triangle, and the offset, that is, the distance of the 'pitch' of one revolution of the spiral, as the other side of a right triangle. The hypotenuse of the triangle is the equall to the circumference of the inner edge of the spiral wrap. Hope I have obfuscated this for everyone.:-)
If I only had the time, I'd build one of these myself.
Brian Trubee
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org