Paul, I don't think the wrap around exhaust will be that easy to
build. Some welds may be difficult to reach Also, a ten inch
diameter muffler will force the use of a wider cowl. One of the strong
appeals of the rotary is the narrow foot print. Still, I think it
should be tried. My simple CAD abilities cannot deal with the shape of
the ellipse created when the sheet metal goes around the muffler at an
angle. Can you supply that for me? Please include the DXF. I would
like this better if the muffler was 4" diameter. Has nothing to do with
performance, just appearance. But what is the difference in
performance? I would build the prototype out of 604SS because the
muffler tube is available. Also, if the length of the muffler is
toward the firewall with the outlet at the rear, there will be less
conflict with MM tubing........Jerry
I have already given welding it some thought and some of the
welds will have to be done from inside the can. Then the
ends welded on. Or weld the square down pipe on the front
end with a 180 bend. Aft end with a S bend. Either
one will look cool :-) However I suspect that will result in
an increase in back pressure and a reduction in HP.
The rotary is 10 inches wide. Half of that is five.
Five and ten is 15 so in theory it will fit in a 30 inch wide cowl.
Give it another inch or three for clearance and you get a 36 inch
wide cowl. Most side by side airplanes are at least 40 inches wide.
My 182 is 48 inches wide. It will fit in my Kis Cruiser
cowl no problem. A TO4 turbo and HKS manifold sticks
out beyond that.
BTW don't overestimate the importance of making the cowl pointed
in the top view. It will do little if anything to reduce the drag.
It might help the prop efficiency a small amount. Max frontal area
is max frontal area and that usually occurs right where the pilot
sits in a side by side airplane. Old tandem airplanes like
the RV4 and three are another matter. The RV8 and other tandem
airplanes have the wider cowls.
I would be guessing about the difference in performance with a
four inch can. I suspect it would be less.
It will be awhile before I have time to do that ellipse
but it should not be hard. Perhaps some of the other math
types on here can do that for you. You could mock it up
in card board and transfer the pattern to the steel.
Paul Lamar
The Limo EZ is 22" at the firewall. Some additional area can be used
beween wing root and the upper and lower cowls. I am all for smaller
diameter. I want to feed the output of the muffler into an augmenter
located below the engine. Can the welds be done with a Henrob or should
it be left to professionals? Thanks
Joe Berki
You got me there Joe. I have never used a Henrob.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org