Subject: E-shaft oil jets
From: ACRE NL
Date: 5/7/2002, 7:27 AM


Tom Kendall wrote:
 >
 > When I disassembled my engine, I removed the oil jets.  Bunged up one of
 > them pretty bad in the process too.  I haven't seen anything on
Mazdatrix'
s
 > page about replacement jets.  Anybody have experience with getting
 > replacements, fixing up jets with stripped heads, or otherwise making
them
 > work?
 >
 > Tom Kendall


     I will type this fast, before Lamar takes off and leaves us for dead. If
you are talking about the E shaft jets, I take them out with an impact screw
driver. Harbor Freight, about $7.00. (Less likely to bugger up the slot.) I
discard the ball and spring and replace it with a Webber .180 main jet from
an IDA carb. Just screw it back in with red Locktite and stake it again. You
can get them from a dealer or anyone who works on Mazdas. If the thing is not
totally destroyed, Use a hacksaw to reestablish the slot, and keep right on
building. If you absolutely can't get one anywhere I will send you one.
Lynn E. Hanover

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org