Subject: E-shaft oil jets
From: ACRE NL
Date: 5/7/2002, 7:29 PM


Mazdatrix has the jets, I don't have the part # because I'm at work, but Tracy's book has the part number in it. I don't know how bad you bunged up the e-shaft jets, but you might want to run a tap and die over the threads if you can find the right size tap and die. Then re- install them with Locktite or even JB weld if you're sure you'll never have to remove them again.
Brian Trubee


Has anyone tryed to remove these oil jets complete??  What happens if you do??
The guys at Hayes Rotary Engineering recommended this to me last year.
Don


Really?
I would think you would lose too much oil pressure to the bearings.
Perhaps they mean plug them up. That would cause the rotor to overheat
in high power aircraft use.

Paul Lamar


I think their recommendation is to remove the springs and the ball so that oil flows constantly not just when the engine is warm.  That's what they're doing to my engine, anyway.

Rick Girard
13B + LEZ


Rick,
Now that you mention it, that is what they told me too.........to remove ball and spring and screw the jet back into the e-shaft.  SORRY !!!!  They say the mind (memory) is the second thing to go!!!!
Thanks for setting me straight!!
Don

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org