> > > Mazdatrix has the jets, I don't have the part # because I'm
at work, but Tracy's book has the part number in it. I don't know
how bad you bunged up the e-shaft jets, but you might want to run a
tap and die over the threads if you can find the right size tap and
die. Then re- install them with Locktite or even JB weld if you're
sure you'll never have to remove them again.
> > Brian Trubee
Has anyone tryed to remove these oil jets complete?? What happens
if you do??
The guys at Hayes Rotary Engineering recommended this to me last year.
Don
Really?
I would think you would lose too much oil pressure to the bearings.
Perhaps they mean plug them up. That would cause the rotor to overheat
in high power aircraft use.
You need to remove the spring and ball and install a 200 weber main
jet in the screw in e-shaft jet, this will give better cooling to the
rotors, if you plug them completely you will have a rotor seizure.
Ken Welter
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org