Mazdatrix has the jets, I don't have the part # because I'm at work,
but Tracy's book has the part number in it. I don't know how bad you bunged
up the e-shaft jets, but you might want to run a tap and die over the
threads if you can find the right size tap and die. Then re- install them
with Locktite or even JB weld if you're sure you'll never have to remove
them again.
Brian Trubee
Has anyone tryed to remove these oil jets complete?? What happens if
you do??
The guys at Hayes Rotary Engineering recommended this to me last year.
Don
Really?
I would think you would lose too much oil pressure to the bearings.
Perhaps they mean plug them up. That would cause the rotor to overheat
in high power aircraft use.
Paul Lamar
The jets have smaller holes than the stock Mazda jets but still flow more
oil since the springs and balls are removed. This improves rotor cooling on
truely high output rotaries. Oil pressure at idle will be lower but this
is of little consequence. Since I don't push the limits on the 13B, I still
use the stock jets.
Tracy Crook
tcrook@rotaryaviation.com
www.rotaryaviation.com
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org