Jerry Hey wrote:

Paul I sent this photo yesterday but it never showed up on the
newsletter.  Today we are making the Barry Mount holders.  The stand
offs hopefully will done in time  to post some photos of the entire
package  before the newsletter shuts down.     Jerry

That is beautiful Jerry. Do the same thing for me.

Weld a thick 6.25 inch diameter flange to a piece of four inch dia. steel
pipe three feet long. Bolt the steel flange to the center of the plate
with 12... 1/4 inch screws on a 5.875 inch bolt circle. Clamp the plate 
all around to something strong with a vertical orientation. Hang 200 
pounds off the other end of the steel pipe and measure the angle of the 
steel pipe before and after with a bubble protractor.

It is too hard to calculate this sort of thing short of a finite analysis program.

BTW Mr. Any Mouse a machinist bubble protractor will measure down to about one degree
resolution. Anything less than that is not worth worrying about.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org