Subject: Recertifying into Experimental category - was - Recommendation from Howaard Jenkins
From: ACRE NL
Date: 5/7/2002, 7:21 AM

Wrathall Mark wrote:

Royce wrote:
A friend of mine who is a CFI (not that that makes him know anymore than
we) was
looking at two certified Bonanza's that were partially dismantled and he
wanted to
buy them, make some modifications to them, and license them as
experemental with a
Soob engine.
We would like to do the same with the Cessna 337 (oscar duece, O2 charlie)
and
hang a three rotor on the aft engine mount, and some dead weight in the
nose for
balance or something.
Royce


Mark  wrote
Royce, you need to read the FAR's which govern the experimental category.
There are a number of sub-category's, of which the Experimental-amateur
built is the one of most intest to us. To get an aircraft into this
category, you are limited by the 51% rule. If you buy a dismantled Bonanza
and install a 20B, you have no chance of getting certified in this category.

I just reread your post, a Bonanza with a Soob? Replace a 250 HP engine with
a 150hp + BS marketing engine. Please give your CFI a reality check lesson
of duty cycles and HP ratings. Good luck getting that flying.

You would need to prove that you manufactered 51+% to get this
certification. If you take a detailed look at the Vans quickbuild kit for an
RV-8, it will give you an idea of what you would need to build. Looks like
the FAA is quite happy accepting that amateurs don't touch the spar, but you
need to manufacture and install at least one of everything else, eg one rib,
one wing skin etc.

This still seems doable, until you realise that Vans are designed for
minimum tooling manfacture, whereas that 337 was designed for mass
production, and will thus be full of castings, extrusions, complex machined
parts, and coatings,  which most guys can't easily duplicate in the shed.
Are you set up to fabricate landing gear components?

Best chance would be to work in advance with the local FAA office to define
what workscope they will accept as meeting the 51% and get this well
documented and accepted from them. This implies buying a wreck, and the
amount of work and cost involved will likely exceed that building a
kitplane. This only really makes sense if you really love the specific model
of plane enough to accept the extra hassle, or you do it on a WWII war bird
where the resulting airframe value is enormous.

If you throw a wankel in a certified airframe and spin a bit of BS, you will
probably get certified in the Experimental - development flight test (or
something like that) category, but it will be a certification limited; in
duration, in flight hours, to neccessary flight test personal, maybe in
location. This sounds like what happened with the Grumman. The guy thought
he was bending the rules, now he has flown off the 50 hours that were
approved, he has an uncertified aircraft, which is almost unsaleable, and no
money to pay an A&P to reinstall a Lycontinental and perform the annual
inspection and paper work to recertify it back into the standard category.

Some A&P will wait till the price drops to near zero, snap it up, throw in a
run-out LyCon of the correct model, recertify it and flog it off for a huge
profit.

Mark Wrathall.

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org