Subject: What to do with the pocketed plate.
From: ACRE NL
Date: 5/7/2002, 11:11 AM

Blake I came up with an idea for my pocketed plate.

Weld a thick 6.25 inch diameter flange to a piece of four inch dia. steel
pipe three feet long. Bolt the steel flange to the center of the plate
with 12... 1/4 inch screws on a 5.875 inch bolt circle. Clamp the plate 
all around to something strong with a vertical orientation. Hang 200 
pounds off the other end of the steel pipe and measure the angle of the 
steel pipe before and after with a bubble protractor.

It is too hard to calculate this sort of thing short of a finite analysis program.

BTW we used to do this with our race cars to measure the over all toe and camber
stiffness of the suspension system. Free racing secret tip for you Lynn.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Plate_Wide_Angle.jpg