Tom Webber wrote:

Ok,  This is my first message and question.  I hope somebody out there can assist in my project.

I'm building a light experimental aircraft,  "Corby Starlet" Single place mostly wood aircraft.  Designed by John Corby in the 60's.
Anyway the plans call out for the V.W. engine. with a weight of 140 to 150 lbs. @ 45 to 60 hp. well I want to use a single rotor Mazda variant.
I've seen a picture of one but have failed to find any technical information on how to go about this.  Does anyone know where to obtain a single rotor E-shaft?

Right now you have a couple choices for an e-shaft.
Make one from a 2 rotor shaft, buy one from Ross aero.
Dave Atkins only sells the engine as a turnkey package. No components.
Paul do you know what these shafts are made of. Cast nodular iron, forged steel, billet steel, chromalathium?

I don't think they are cast iron. PL

If you simply cut down a 2 rotor you will end up with about the same weight and power as the veedub..

Royce

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org