Subject: Trip to OZ / 20B timing
From: ACRE NL
Date: 5/8/2002, 10:38 AM


 Hey Paul,
 Before you take off for your trip to OZ.  Can you give me some info on the
 easiest way to set the timing on my 20B.  I believe it the same as on the
 13B.  My pulleys have NO marks, so what are the reference points for TDC and
 what is the best way to determine where I should place timing marks???  I've
 finished all my wiring now (EC2).  Just a little more plumbing and a muffler
 and I'll be ready for the first start!!!
 Thanks,
 Don


You got me there Don. I know nothing about 20Bs.
OK you 20B guys here is your chance :-)
BTW check your flywheel for marks. Just a wild ass guess on my part.
Paul Lamar


OK all you 20B guys (Tracy, Robin, Bob, Barny, etc.),
How do you set the initial timing of the CAS if you have no timing marks on the Damn pulleys or you don't know what degree from TDC a mark represents???  Also, what exactly does TDC mean in a rotary????  I'm assuming that the timing is set the same way as on a 13B but I don't know for sure.
HELP !!!
Thanks again,
Don Mitchell


Since we did not have any 20B guys chime in I will give it a stab.
Let us assume the exhaust manifold is off the engine. Look through
the exhaust port and turn the engine clockwise until the front rotor apex seal
just passes the exhaust port.  Rotate the engine plugs up. Remove
one spark plug on the front rotor. Fill the combustion chamber with oil.
Jiggle the e-shaft back and fourth rather quickly and add oil until the oil level
comes up to the top of the spark plug hole and starts to go back down
as you continue to rotate the e-shaft back and fourth.
That is top dead center. Mark the front pulley or the flywheel. If the seals
are leaking badly this won't work.  A clear plastic tube inserted in the
spark plug hole somehow will work even better with this trick.
Paul Lamar


That is a good trick Paul, I will remember that one.
Regards Don

I think it was Lynn Hanover that came up with this.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org