From this chart you can see that 31 inches is about right
and that is the length of the square pipe wrapped around the
muffler can. If somebody wants to build one of these I will
test it on our new dyno in about couple of months or so.
Paul Lamar
Yes I think it does to a certain extent but I am not entirely
sure to what extent. That data was taken with a p-port and a
relatively short intake pipe but I know not what diameter.
Diameter of the pipe also has an effect on tuning surprisingly.
Mazda did that because they were looking for good power
over a wide RPM range. Very important for a road racing car.
Here is a chart of P-port intake length verses BMEP from the same
SAE paper. I suspect we are running pipes a bit too long
for 6000 to 7000 RPM. I think Chuck Dunlap may be having this problem.
I removed my oil filler neck and will
be looking into a way of shortening the intake pipes just
a bit and still get oil in the engine. I will move the intake
plenum up over the rotor housing a bit.
The time has come for a little dyno tuning to nail some of this stuff
down for aircraft use.
Paul Lamar
A peak bmep of 144 psi sure does not look like any 120 percent
volumetric
efficiency, when a garden variety Cont IO-360 pulls more than 170
Vance
That was for this particular test. As I said I have no idea what
the port size was. For all I know it was a one inch diameter
P-port. Mazda is not always totally fourth coming in their SAE papers.
The Leman engine was designed after these tests and the pipe size
chosen was huge. The Leman engine obviously has a volumetric efficiency
well over 100% over a very wide range of 6000 RPM to over 9000 RPM.
It is just plain common sense that a hole almost the size of the bore,
with no poppet valve getting in the way, is going to breath well.
This study provides evidence of why Chuck Dunlap's engine is down on
power.
As the pipe is made smaller the optimum RPM is reduced and the
power falls off faster at higher RPMs. Chuck is using long pipes of
relatively small diameter so he is probably losing power around
6000 RPM and above. It took me a long time to figure out the
Mazda dynamic chamber but that is another story for another time.
Paul Lamar
What is the recomended intake pipe diameter? I thought that you used 1 1/4
on the center ones and 1 1/2 on the outer pipes. Is this not correct?
Wendell
That sounds like you are talking about the new intake manifold casting. Yes.
That is pipe sizes. Different than tubing size unfortunately.
I am using sched 40. Here is a pipe size chart.
Paul
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org