I am thinking of going with this company for pattern work.
http://www.flashcutcnc.com/html/ord_price.html
Anybody had any experience with this sort of stuff.
It interfaces with Rino CAD. Anybody running Rino CAD?
Paul Lamar
Paul,
I run Rhino. It is a great package. If you are used to ACad, You will have
no problem because they have a similar structure and are compatible with
each other. Rhino only runs under windows, no Unix. Rhino works great for
surfacing. The solid modeling is rudimentary at best. Blending is a bit
limited. But overall, especially considering the price, it is great. I am
really not being fair, because I am comparing a $900 package with $25K+
packages.
As far as flashcut is concerned, a friend of mine has a mill similar to the
one you show. I think you will be very disappointed in the mill if you
intend to do serious pattern work. What you really need is a 3D router. The
mill does not have a large enough work area, plus the G codes etc available
with the smaller mills usually are lacking. They work great for jewelry or
hobby stuff, but for big stuff they just don't have the power or travel. I
have retrofitted an older model Bridgeport Boss mill. They have ball screws,
stepper motors, and are industrial quality. The controls suck, vintage early
80's, but the machines are great. I have seen them go for as little as $1500
lately. Solution: remove old controls in their entirety, pitch them in the
trash, replace with modern PC based controls running under DOS. The only
problem is the work area is only 18X12X5 in. The larger series II mill is
24X18X5. For pattern work you can build or buy a 3D router which will handle
much larger pieces. You can use a much less massive machine, because you are
cutting wood or plastic, not tool steel. If you are clever in how you
design it, you can also mount a plasma cutter in the head and have a plasma
cutting table for flanges, brackets etc.
Attached is a photo of my Bridgeport series I Boss 5 mill, retrofitted with
AH-HA Controls.
AH-HA makes a good stable FANUC compatible control for shops that depend on
their mills for income. They are a bit pricey though.
http://www.ahha.com/index.htm
Best bang for the buck in PC based controls:
http://www.yeagerautomation.com/
Realistically, if you are not going to do a LOT of this kind of thing you
are probably better off paying somebody to make your patterns. There are a
lot of ancillary things you need to make a mill work. Tooling can cost a
bundle. Get Rhino, learn how to use it then email your files to a prototype
shop and they Fed EX you a nice finished part. I do it all the time.
Monty
Funny you should mention Rino. I just downloaded the demo good for 25 saves.
I got further learning that in a shorter period of time then I ever got with Solid Works.
I sense the limitations however. May not be good enough for intake runners.
Thanks for the advice on mills. The core boxes I want to build are about 4 inches
by 6 inches by 10 so even a small mill will work. My total budget is $3000.
I want to be able to make mistakes and do them over. Are the lead screws unacceptable
for NC in small chinese mills? If so can they be changed at a reasonable cost?
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org