Monty Roberts wrote:
<snip >
Funny you should mention Rino. I just downloaded the demo good for 25
saves.
I got further learning that in a shorter period of time then I ever got
with Solid Works.
I sense the limitations however. May not be good enough for intake
runners.
Thanks for the advice on mills. The core boxes I want to build are about 4
inches
by 6 inches by 10 so even a small mill will work. My total budget is
$3000.
I want to be able to make mistakes and do them over. Are the lead screws
unacceptable
for NC in small chinese mills? If so can they be changed at a reasonable
cost?
Paul Lamar
Acme screws are unacceptable. You can use a double nut and constantly adjust
backlash, but it is a loosing battle. Buying new ball screws and steppers
would shoot your budget. That is why the Bridgeport is so attractive. It
already has those high price goodies. If you were willing to sacrifice on
the speed you could use the $600 geko drive and controller setup with a
Bridgeport mill for a really low buck killer setup.
I assure you Rhino can handle any intake manifold shape you want. Try
playing with the loft command. If the following can be produced in Rhino, an
intake should be a piece of cake. If I wasn't so busy with the house and
work, I would do it for you. Send me a dxf 3 view, and I might be able to do
a quickie if it isn't too complex. Once you see how to make things it isn't
so hard. In the beginning there is a lot of banging your head against the
monitor. ;^)
Monty
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org