Don Dunbar wrote:

Hi Paul and Robin,
Good to hear you had a good trip and arrived home safely. Thank Robin
for the card from Nidia and myself.
Paul can you check what version of prolines that I gave you as it may be
the latter one that won't work with that dongle. I can email the right
one I think as the dos program's are small.

I will check to see which one I should have given you.

My PRSU is close to completion but may not get to see it before Nidia,
Ali, Brent and myself go north to exmouth fishing for three weeks, we
expect to leave on the 27th of this month.
I will try to send some photos of the PRSU before I leave.
Brent and myself trailed the new 25 foot center consul fishing boat that
we will take north today.
It has a 130 hp Honda four stroke outboard on and is very impressive
with a maximum speed of 32 knots loaded. This engine is so quite at full
power at 5800 rpm that if you go to the bow it can't be heard.

I will send some fishing photo's of Exmouth and that will wet your
appetite, this is gods country as I say. I think it is a bit like
southern  US coast climate but has the coral reef 3 mile offshore for 80
miles of coast.

The mustang has taken small steps forward with the purchase of VHF and
Transponder, engine feet are finished on the engine and I have all the
chrome molly tube to complete the rest.
Well Paul I will say goodnight and catch you later, Regards Don.

OK Don. Will try the earlier versions. Thanks for the up dates and
have fun on your vacation.

Paul Lamar

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org