Subject: Rotary displacement verses piston engine displacement.
From: ACRE NL
Date: 6/27/2002, 9:55 AM


VJ & Paul wrote: Snip...Snip

BTW the tooth contact is not a fulcrum as the pressure on the face
of the rotor is considered perpendicular, uniform and centered over the
eccentric.
The measured tooth loads confirm that tooth load is totally unrelated
to anything but RPM. I have some charts of tooth loads in case you
are interested.

VJ - OK, I give you that - it is mostly a timing and anti tipping device -
but the engine will  self destruct if one breaks.

Yes of course. See the chart below. Improvements in gear mounting
technology have been made since this chart was published.

 [Image]


Paul,

I have been following this discussion fairly well but the "Reverse Rotation"
in the chart threw me. Could we have an explanation ? BTW that chart gave
me a much better appreciation for a 6,500 rpm redline for aircraft
applications !!

Fred O.

It throws me too. I have no idea what they are talking about.
It my have something to do with the over run. When you let up
on the gas and the inertia of the car drives the engine this
could be the case. I say this because the loads on the phasing
gears are also a function of what kind of transmission is in use.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org