Subject: Rotary displacement verses piston engine displacement.
From: ACRE NL
Date: 6/27/2002, 8:14 PM


VJ & Paul wrote: Snip...Snip

BTW the tooth contact is not a fulcrum as the pressure on the face
of the rotor is considered perpendicular, uniform and centered
over the
eccentric.
The measured tooth loads confirm that tooth load is totally
unrelated
to anything but RPM. I have some charts of tooth loads in case you
are interested.

VJ - OK, I give you that - it is mostly a timing and anti tipping
device -
but the engine will  self destruct if one breaks.

Yes of course. See the chart below. Improvements in gear mounting
technology have been made since this chart was published.

 [Image]


Paul,

I have been following this discussion fairly well but the "Reverse
Rotation"
in the chart threw me. Could we have an explanation ? BTW that chart
gave
me a much better appreciation for a 6,500 rpm redline for aircraft
applications !!

Fred O.


It throws me too. I have no idea what they are talking about.
It my have something to do with the over run. When you let up
on the gas and the inertia of the car drives the engine this
could be the case. I say this because the loads on the phasing
gears are also a function of what kind of transmission is in use.

Paul Lamar

In any case, I believe that what they are showing is cyclic load reversal,

and 500kg (1100lbs) is not to be sneezsd at and the slope of the curves
predict  a very real chance of trouble ahead at higher rpm - Vance J


Which curve Sunshine? :-)  This late 12 pin version shows the loads are trending downward
from 8500 to 9500 RPM. I am pretty sure Mazda means when the engine is
back driven through the transmission. Not cyclic load reversal. 
Just a japanese to english translation problem.

You sure are a pessimist. You are finding it hard to accept the boing boing is
history aren't you :-)

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org