Walter Williams wrote:
good to have you back Paul, wondering if anyone has a cnc program to cut the 13b e shaft down to a single rotor. or any good ideas for the most reasonable way to do it . where should i send the check to get the newsletter cd. i lost all my saved newsletters up to about 2-01 when l changed servers. i seem to recall an oz or new z co that was making new ones 2 or 3 years ago. any help much appreciated. walt williams. wgw75@attbi.com
Tom Webber wrote:
Walter, The following web site is for Guru motor Sport in Oz. They have a two piece E-Shaft, which I believe could be made into a single rotor fairly easily. I've been in contact, but with only minimal results. They will sell the two piece part, but I as you only need the single rotor configuration. Let me know what you come up with. Thanks T.W.
The following is a my last communication with Guru from Oz.
---------------------------------------------------------------------------------------------
Hi Tom,
Yes we do sell the 2 piece and can supply this no probs.
The center piece of the e-shaft is one piece and we then slip on the next
etc, do you have a diagram of what you are after, and we can see if we can
modify our one etc for you.
Cheers, Kelvin
This is there web site and it shows the two piece e-shaft.
http://www.gurumotorsports.com/eccentric_shaft.htm
---------------------------------------------------------------------------------------------------
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org