Subject: Rhino CAD intake runners.
From: ACRE NL
Date: 6/28/2002, 10:14 AM


Hi Monty,

This is as far as I got in three or four hours.
A lot further than I ever got in Solid Works.
How do you make a "closed" oval as opposed to an ellipse.
I tried almost everything and it won't "loft" unless all
curves are "closed".

I am not getting much out of the book. Most learning progress is
by trial and error.

Paul Lamar


The book is pretty useless. Not sure what you mean by "closed". Email is too
low band width for these type things. In 20 minutes of demonstration I could
have you making manifolds like crazy. Phone would be better than email. Not
sure when I can get a chance to call, maybe evening during the week. Check
out the conic command if you want a generalized form of conics. It is
possible to create anything from a circle to a square edge by varying the
rho value. I think there is also a tube or pipe command that is pretty neat.
I'm pretty sure you can create a loft with open curves, but you can't
combine open and closed in the same loft. I'll check tommorow, right now I'm
going to bed.

Monty

The problem with this stuff is we are working in 2D. The real world
is six degrees of freedom. Pitch, roll, up, down, left & right.
We need a joy stick that you could twist. You could grab a bulkhead
and twist it or rotate it as well as moving it around.

Heck in the old days we would use the cursor keys for translation
and a couple of other keys for rotation.

So far I have not been able to find out how to move a bulkhead once
it is in a wire frame.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org