Hi,
Thank you for your e-mail.
We are doing a another run shortly of '20b' cranks for 'standard
plates',
but we can also likely supply 'genuine plate' cranks, what
specifically
are
you after and numbers expected/required etc?
Regards, Rohan Ambrose gururacing@gurumotorsports.com
I see you have a 2 piece `13B shaft. We here in the States need a
source
for replacement 20B shafts! Any thoughts?
Marc Wiese
Well, it looks like we have a source for 20B eccentric shafts, no? I
don't know what to tell him about our needs. Does anyone know what he
means about "plates".
Marc Wiese
Perhaps he is referring to the side housings? But what is a "standard"
plate crank as opposed to a "genuine" plate crank?
Kelly troyer
Maybe he means that he can build a shaft to use either the
thicker 20B 'center' (intermediate) housing or to use 2 13B
center housings.
Charlie England
david mccandless wrote:
For Marc Wiese,
Marc I have had no luck with that Website for gurumotorsports, could you
check it again? I'd like to speak to them ref single rotor E shafts. Ta,
Dave McC
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org