I see you have a 2 piece `13B shaft. We here in the States need
a
source
for replacement 20B shafts! Any thoughts?
Marc Wiese
--------------------------------------------------------------------------------
Hi,
Thank you for your e-mail.
We are doing a another run shortly of '20b' cranks for 'standard
plates',
but we can also likely supply 'genuine plate' cranks, what
specifically
are
you after and numbers expected/required etc?
Regards, Rohan Ambrose
--------------------------------------------------------------------------------
I don't know what you mean by 'standard plates' and genuine plate'
types? Can you clue us in? I know my and others 20B shafts used here
are
originally 2 piece as oem equipment.
I would like to know what kind of steel, the hardening process, etc
you
use for these shafts. We are a large group of rotary users here in
the
states, with many adapting 20B engines to other uses.
I will publicize you answers and inquires to our groups.
Marc Wiese
--------------------------------------------------------------------------
Hi Marc,
Oh sorry re the plate answers, over here many people 'make' up 20B
engines
out of 13B plates but use one of our shafts, i.e. 'standard plates'.
But as you are talking genuine 20B shafts now I understand your needs,
I
will
discuss with our engineer (as he is out of the office today) and will
get
back to you, the short answer is yes we can supply them. I will
forward
the
information on material and hardening process with my next response.
Regards, Rohan...
----------------------------------------------------------------------
Marc Wiese wrote:
Yes, people here too make up 20B type 3 rotor engines, but usually use
the heavy center housing for the oem bearing support and then use the
oem 20B eccentric shaft with other 13 B housings and front and end
plates. How does one build a 3 rotor without the 20B center housing?
Have you done this?
Many of us would be interested if this is possible!!!
Marc Wiese
Marc please try to keep this in chronological order. Easier to follow.
I have also included Rohan on the list for these messages.
Also what about one rotor shafts? There is a much bigger market for
one rotor shafts. I assume these people are in Aus.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org