Subject: Engne mt bracket for ply firewalls.
From: ACRE NL
Date: 6/30/2002, 9:23 PM


Jerry Hey wrote:

Paul,    Hard to believe the labor that goes into one of these little
guys. ........Jerry

J-Wind Designs
Motor Mount Plates,  Engine mounts
j-winddesigns@thegrid.net
831-385-0908

This will work great of course but I think you need to go with the
more
traditional style. You might have a bit of sales resistance
to such an unusual design.

Paul Lamar


I have no problem with building a bracket like  yours but I think this
one will look totally cool once it is installed.   Jerry

It will but cost will become an issue and the single bolt style
will be required on metal airplanes like the RV's. This looks great for
composite airplanes where you can drill holes in the firewall where
ever required.

Paul Lamar


Hopefully, we will be building a lot of the single bolt type.  Not only
for the RV but for the Tailwind and other tube airplanes. Would a single
bolt type with a very wide washer welded on one end would work with
composites?     

Yes. That will work fine as well. 

About costs,  I could not do much to hold down prices on
the MMP but I plan to build the engine mounts for around $300.00. Jerry

That is a bargain. It is tough to build a mount without using a welding
jig and welding jigs are time consuming to build.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org