Subject: Tension Bolts One rotor.
From: ACRE NL
Date: 6/30/2002, 8:36 AM


Royce wrote:

This posting concerns single rotor bolts Paul.
Do you know of a source for them.  I don't think ARP would sell them for
$17.00 each, at least I would hope they would be half that.
The front housing could also be threaded for a different thread size and
use piston engine head  bolts/studs.
The Cadillac front wheel drive V8 engines use a long head bolt that goes
to the bottom of the aluminum block and the original 4.6/4.9L engines
had cast iron heads. I don't remember if the threads are rolled or cut.
Royce

Sorry I did not realize that. You might cut down the stock Mazda 3rd gen bolts.

Paul Lamar

How are they different from the 1st/2nd gen bolts?
Royce

They are full diameter where you need to re-thread them.

Paul Lamar

Excellent Paul
Royce

Go with the 1/2 inch US bolt. Much cheaper. Probably work with the two rotor as well.
As a quick check the bending stiffness is proportional to the
radius to the fourth power while the mass is proportional to the radius
squared so the resonant bending frequency of the 1/2 bolt will be much higher.
It will therefore be less likely to fatigue the 1/2 inch tension bolt.

Paul Lamar

I was thinking we could use long partially threaded 7/16 bolts cut down to the right length but then we would need someone to roll the 10mm threads for us. Might be easier than rethreading the front housing.

Fred O.

So tension bolts  are 10 mm and not 12 mm? That would make it easier.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org