How are they different from the 1st/2nd gen bolts?
Royce
They are full diameter where you need to re-thread them.
Paul Lamar
You might think of drilling everything out and use the next size
American bolt. Looks like there is enough meat in there for a 1/2
inch American bolt. You would have to re-drill & tap of course.
Paul Lamar
david mccandless wrote:
More Weight; Dave
Why is that Dave? Material is removed when you drill everything out.
The difference is minor. 12 MM is .4724 while 1/2 inch is .5000.
Socket head cap screws 1/2-20 180,000 psi eight inches long are $5 each
McMaster Carr.
Paul Lamar
-david mccandless wrote:
I meant heavier wrt the tapered bolt. But, what would worry me is that
the major dia of the existing thread is 12 mm, but according to my
charts the tapping drill size for 1/2" UNF is 11.5mm so already we are
down to about 50% thread area. This is against the whole theory of
having a high tensile bolt, it will just pull the thread out of the cast
iron, even more so in an alum endplate, which usually has a coarse
thread. This MAY rule out the Caddie head bolt mentioned earlier if it
is 1/2"; some fancy alum engines have steel inserts to enable fine
threads as the fine thread gives a more accurate tension tolerance which
translates as more even tension across the head to avoid warping .
Probably why Mazda went for a fine thread in this application. UNC needs
a 10.8 mm hole so the problem is even worse with the coarse thread. I
think that if we go this route then 9/16" is a
possibility as its tapping drill is 12.8mm and this size is fairly
common and I would think there is enough meat around the thread bosses
to use 9/16".
But lets see what ARP etc come up with in 12mm, we are talking a 100
plus bolts here. Dave McC
-
I am not even sure if the tension bolt is 12 mm.
Can you confirm the tension bolt is indeed 12 mm? 12 mm looks like a tight
fit in the current rotor housing holes. I don't have tension bolt here.
What is the OD of the threaded portion of the tension bolt?
True 11.5 mm is .4528 while 1/2 20 requires a 29/64 or .4531 tap drill.
A 12 mm bolt requires a 10.2 mm tap drill or 13/32 or .4040.
What would be the length required for a one rotor? My guess is about six
inches or 150 mm. The longest 12 mm bolt from McMaster Carr is 120 mm.
McMaster Carr has even less of selection of lengths for 9/16th bolts.
A preliminary google search was not much help so far.
Looks like this is a bigger problem than I at first thought.
We have been down the ARP route. They are in my home town of Santa Paula
and I went over there and showed them a 2 rotor bolt. They declined
to make any. 100 is not a big enough order for them. I think you would have
better luck in Aus as U.S. companies are looking for custom orders
in the thousands.
Well you could still cut down a Mazda 2 rotor bolt.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org