Gordon Robertson wrote:

Hi fellows,

I am looking for a source of engineering data on the Lord or Barry mounts
for the engine.   I need technical information, plus the dimensions.   I
have checked the Barry website, but to my surprise they dont seem to give
technical specs.

Does anyone know where I can find this stuff?

Gordon Robertson
RV8 - 13b engine installation.

And some more. Can also be used in a composite firewall design.
Not to worry the 1/2 inch bolt can take the momentary bending loads
but the welding cup must be supported by parallel tubes
with the firewall as shown in this Perry Mick implementation.

Paul Lamar

Dean Head wrote:

Group,
I am very interested in the mount discussion as I want to fabricate my Cozy
MK4 mount. I see a couple of way that it has been done and would like to
take advantage of what folks have learned as I construct mine.
Dean Head
Cozy MK 4 #1040

Here is another very good  implementation that uses a steel cross beam under
the back of the engine to hold the Barry rubber mounts by Bill Schertz. 
The steel cross bar fits just behind the oil pan aft vertical
panel. At the top in this jpg.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org