Subject: 5 speed gear ratios
From: ACRE NL
Date: 8/4/2002, 9:05 AM


Peter Cowan wrote:

Rich,
 I'm flying one with mods a little different than George's and can
provide
pictures. Given Paul's (probably justified) dislike of this approach, you
could contact me off the list at: peterc@pipcom.com
Peter.


It is not me personally. I just run Sir Isaac Newton's equations and
Sir Isaac says NO! Perhaps I am running the equations wrong. I would
welcome and publish anybody else that can run Sir Isaac Newton's equations
and come up with a different conclusion.

That is what science and engineering are all about. You specify
a set of numbers about a particular design and everybody else
around the world can verify or disprove them. I welcome anybody
that is brave enough by risking their life alone to yet again verify
the unfavorable numbers by further experiment. Just don't fly over my
house :-)

Paul Lamar

What's the status of George Graham's project?  I have not heard anything
about him in some time. I seem to remember that his gears had stripped. I
was always worried about the prop shaft and gyroscopic loads after seeing it
at Oshkosh a few years back. Is he still flying a mazda trans or has he
switched to something else?
James Phillips

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org