Jerry Hey said:

I ended up making the cover out of .125 6061 T6 extrusion.  This is
marvelous stuff and will look and perform beautifully.  Very tough.
Although it is supposed to be 3 inches wide , it was actually 3.08, a
perfect fit for the cover.

Ernesto Sanchez wrote:

Will the motor mount and cover fit the later model bolt pattern?
Ernesto

Bolt pattern is the same or near the same  but it won't fit that starter.
Easier to get an earlier starter.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org