....l... > >
And Paul is absolutely correct in that O2 sensors usually die
quickly
if
they see ANY lead.
Also keep in mind that 100LL (Low Lead) has a VERY high lead
content.
The
LL description is a hold over from when it was compared to 110
octane
and
other aviation fuels seldom seen any more.
Steve Webre
Broussard, LA
Steve,
I have flown with my O2 sensor installed for 80 hours now using
nothing
but
100LL and it is still working fine with my Air/Fuel Ratio indicator
meter.
I have read that Lead apparently does adversly affect the sensor's
response
time - making it essentially useless for the normal automobile
application
where the computer polls its output in terms of 10s of milliseconds or
so
to
maintain the 14.7 A/F ratio.
But, for use as an indication of oxygen level (and therefore mixture
ratio),
80 hours of 100LL does not seem to have had any noticable effect (if
its
response time has slowed to 100s of milliseconds rather than 10s - it
still
plenty fast for human perception). I do have one of the slightly more
expensive self heated sensors, so don't know if that may account for
its
longer life. But, saying that even a few second of lead gas kills the
sensor does not apply (at least for the Air/Fuel Ratio indicator
usage).
Best Regards
Ed Anderson
"Steere, John" wrote:
Steve;
Is your O2 sensor protruding into the exhaust gas stream or recessed so
it
is not directly impinged by the exhaust stream?
John Steere
John,
My O2 sensor is screwed into a threaded boss that is welded to the pipe, so
the sensing part protrubes approx 3/4" or so into the exhaust flow - there
is no recess. The sensor does not appear to have lost any performance
characteristics needed for an Air/Fuel Ratio indicator such as decreased
voltage output. The 10 LED indicators I use are setup to cover a voltage
range of 0.14 - 0.98 volts and the mixture control can vary the ratio such
that the entire range (and more) of LEDs are lit.
I know that Tracy Crook has also used 100LL on occassion when no auto fuel
was available and has noticed no adverse effects on the sensor. However, I
think my 80 hours pretty clearly indicates that for use as an Air Fuel Ratio
indicator that any degradation effects are pretty long term. The only other
thing I can think of is that perhaps the preheat feature may have had some
effect althought it supposedly only heats the sensor to around 300F before
the exhaust heats it further. Only used so that you get the sensor working
faster on engine start.
I know - I was told that even a few seconds of leaded gasoline was death on
an O2 sensor, but for A/F ratio indication that does not appear to be the
case.
Ed Anderson
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org