Jerry Hey wrote:
Hi Paul, After spending all day yesterday figuring out how to build
the wrap around fly wheel cover, I discovered this morning that it is
not going to work after all. While the wrap fits the MMP just fine ,
it hardly bears at at any point on the bell housing which is really a
series of flats. Most of the circular fly wheel cover is outside
of the periphery of the bell housing, sometimes way outside of it.
In fact, it has less bearing surface than Tracy's spacers which I
appreciate more and more. I'm glad I have a set for my project.
If you want to have the spacer bearing on the bell housing all the
way around the only way is to construct it out of a number of
pieces that are welded between the spools. Each piece well have to
be individually shaped to match the bell housing where it is at.
This is not a simple problem. It also makes casting the spacer a
daunting project.
Jerry
It is just a cosmetic thing anyway. Later on I will do a pattern
for a complete cast bell housing.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org